Generic Type Inorganic Zinc Silicate

Description

A low VOC member of the Carbozinc family with extraordinary corrosion resistance properties.
Carbozinc 11 HS combines unparalleled performance characteristics with an ultra-low VOC
formulation that meets some of the most stringent VOC restrictions.

Features

• Meets Class B slip co-efficient and creep testing criteria for use on faying surfaces
• Rapid cure. Dry to handle in 1 hour at 75°F (24°C) and 50% relative humidity
• Low temperature cure down to 15°F (-9°C)
• High zinc loading
• Very good resistance to salting
• May be applied with airless or conventional spray
• Excellent as a lining for solvent storage
• May be used as a weldable pre-construction primer
• Exhibits long-term corrosion resistance
• Low VOC level for solvent-based inorganic zincs

Color Standard: Green (0300)
Special Order: Grey (0700)

Finish Flat

Primer Self Priming

Service Temperature

Untopcoated
Continuous: 750°F (400°C)
Non-Continuous: 800°F (427°C)
With recommended high heat topcoats:
Continuous: 1000°F (538°C)
Non-Continuous: 1200°F (649°C)

Dry Film Thickness

2 – 3 mils (51 – 76 microns) .
0.50-1.00 mils (12-25 microns) per coat for weldable, pre-construction primer. 2.0-5.0 mils for OEM
applications in controlled environments. Dry film thickness in excess of 6.0 mils (150 microns) is not
recommended.

Total Zinc Dust in Dry
Film
By Weight: 84%

Solids Content

By Volume 75% +/- 2%
Measured in accordance with ASTM D 2697.

Theoretical Coverage
Rate
1203 ft2/gal at 1.0 mils (29.5 m2/l at 25 microns)
602 ft2/gal at 2.0 mils (14.8 m2/l at 50 microns)
401 ft2/gal at 3.0 mils (9.8 m2/l at 75 microns)
Allow for loss in mixing and application.

VOC Values

Thinner 26 : 15.28 oz/gal: 2.95 lbs./gal (354 g/l)
Thinner 33 : 15.28 oz/gal: 2.95 lbs./gal (354 g/l)
As Supplied : 2.4 lbs./gal (288 g/l)
Thinner 236 E : 38 oz/gal: 2.4 lbs./gal (288 g/l)
Thinner 254 : 8 oz/gal: 2.73 lbs/gal (327 g/l)
These are nominal values. When used as a pre-construction primer thin up to 38 oz/gal using
exempt Thinner 236 E.

Topcoats

Not required for certain exposures. May be topcoated with Armorlast Series inorganic
silicate finishes. May also be topcoated with Waterborne Acrylics, Epoxies, Polyurethanes,
HighTemperature Silicones and other coatings as recommended by Carboline. Under certain
conditions a mist coat may be required to minimize bubbling.